Furuno B042-016, B042-004, B042-008 Transducer setting, Display unit, rear view, Terminal board

3. INITIAL SETTINGS

Transducer setting

Change the terminal board setting at the rear of the display unit according to the transducer connected.

Note the alphabet which appeared when selecting the transducer type on the installation main menu (page 3-4), and then do the following procedures.

1.Dismount the display unit from the mounting place.

2.Loosen four screws to remove the rear cover.

Note: There is no gasket for lid. (The groove around the terminal board does not hold a gasket.)

12-24_VDC

NMEA

TEMP

H

L

Loosen these screws.

Display unit, rear view

3.Fasten the crimp-on lug to the appropriate terminal according to alphabet appearing on the installation menu.

L		H
A B C	D E	A B C D E
TB10 TB9 TB8 TB7 TB6		TB5 TB4 TB3 TB2 TB1

For Low Frequency For High Frequency

Terminal board

4. Remount the display unit.

3-5