5.2Calling a Station
1.Press function key [F3] to display the Operate menu.
Operate
1:Call Station
2:Macro Operation
3:File to Send
4:Cancel Sending
5:Scan (Start/Stop)
6:Manual Reception
7:Timer Operation
8:High Tension ON
9:Manual Calling
0: Set Frequency
Figure 5-4 Operate menu
2.Press the [1] key to display the Station List.
3.Select the station you wish to call.
4.Press the [Enter] key to establish connection with the station.
1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
|
|
|
|
|
|
|
| Caps | |
Station Name | : |
|
| ||||||
Frequency (T/R) : | 8765.00 | / 8965.00(kHz) | Comm Mode :ARQ |
| |||||
Comm Status | : | Connect |
| Send |
| Lock | Error |
| |
Sending Volume | : | 100(%) |
| ARQ Error : 0 | ARQ Time : 0(sec) |
| |||
Figure 5-5 Communication status display
"Connect" appears in inverse video on the Comm Status line when an acknowledge signal from the station called is detected. (In the ARQ mode connection may be delayed due to signal condition. In the FEC mode, however, "Connect" appears in inverse video a few seconds later since the acknowledge signal is not required.)
