Furuno FE-700 installation manual Transducer, Type

F type

Flush Mount Kit (F):		OP02-79-1 (001-229-290)
		OP02-79-2 (001-229-300)
		OP02-79-3 (001-229-310)
No.	Name		Type	Code no.	Qty	Remarks
1	Cosmetic		02-129-1041-0	100-279-270	1	OP02-79-1:N3.0
				100-279-280		OP02-79-2:2.5GY5/1.5
	panel
				100-279-290		OP02-79-3:7.5GY7/2
2	Hex bolt		M6x12	000-162-897-1	4
				0
3	Spring		M6	000-158-855-1	4
	washer			0

1.Prepare a cutout in the mounting location whose dimensions are 210 (W) x 194 (H) mm.

2.Attach the cosmetic panel (02-129-1041-0) to the display unit with four hex bolts (M6x12) and four spring washers (M6).

3.Fix the display unit to the mounting location with four tapping screws (5x20).

S type

Flush Mount Kit (S):		OP02-80 (001-229-320)
No.	Name	Type	Code no.	Qty	Remarks
1	Fixing plate	02-129-1045-0	100-279-300	2
2	Wing bolt	M4x30	000-804-799	6
3	Hex bolt	M6x12	000-162-897-1	4
			0
4	Spring	M6	000-158-855-1	4
	washer		0
5	Wing nut	M4	000-863-306	6

1.Prepare a cutout in the mounting location whose dimensions are 194 x 194 mm.

2.Insert the display unit to the cutout.

3.Attach two fixing plates (02-129-1045-0) to the display unit with four hex bolts (M6x12) and spring four washers (M6).

4.Screw six wing bolts (M4x30) to wing nuts (M4).

5. Fasten the display unit with six wing bolts and nuts.

1.3 Transducer

The installation of the transducer and the tank should be accomplished by a dockyard referring to the installation drawings at the back of this manual. An example of transducer installation method is also shown in paragraph 1.3.2.

Note: Discussions should take place and agreement reached with the dockyard for sufficient reinforcement and watertightness of the hull to comply with the regulations concerned.

4