4. ADJUSTMENTS
This section provides the procedures for initial set up of the equipment. The type of transducer used should be properly set before operating the equipment.
4.1Transducer Setting
Select the type of transducer used as follows.
1.Press the POWER Switch while pressing any key. Release the key when the following display appears.
EXTENSION MODE
+ : TRANSDUCER SETTING
▲: CLEAR MEMORY
▼: DEMONSTRATION
2. Press the [+] key to select TRANSDUCER SETTING.
TRANSDUCER SETTING
CHANGEOVER : AUTO MANUAL [FORE] XDR : N/A 50kHz 200kHz KEEL DIST. : 0.0
[AFT] XDR : N/A 50 kHz 200kHz
KEEL DIST. : 0.0
DEPTH(BELOW) TRANSDUCER KEEL DISP MODE : DUAL SINGLE
DISP ORDER*: AFT/FORE FORE/AFT OUTPUT* : FORE AFT
MEMORIZE* : DUAL FORE AFT
:To select item
-+: To set option
*Does not appear when DISP MODE is set to SINGLE.
3.Set the transducer(s) as shown below. Use [▲] or [▼] to select an item and [+] or
a)CHANGEOVER sets how transducer(s) is connected to the
b)One transducer installed: Set FORE XDR to 50 kHz or 200 kHz, depending on actual installation. Leave AFT XDR set to “N/A."
Two transducers installed: Set FORE XDR and AFT XDR to 50 kHz or 200 kHz, depending on actual installation.
c)KEEL DIST sets the distance from transducer to keel of the ship.
d)DEPTH (BELOW) selects the method of depth indication. TRANSDUCER for depth indication below the transducer (except DBS mode), or KEEL for depth indication below the keel.
e)DISP MODE sets the function of the MODE switch in case of dual frequencies. Select DUAL to show the dual frequency display (fore and aft), or SINGLE to show single frequency display.
22