Furuno GP-1610CF Initial Settings, Sensor connection, Autopilot or remote display connection

1.6 Initial Settings

Sensor connection

This section should be done with the boat in water.

1.Turn on the power and press the MENU key.

2.Press the [0] key.

3.Press the [5] key to select SENSOR SETUP.

SENSOR SETUP

	SPD SENSOR	STW	SOG
	TEMP SENSOR
		OWN	NMEA
	SPD CALIB	-00%(-50~+50)
	TEMP CALIB	+000°C
	DEPTH CALIB	+0.0m
	: Cursor		: +/-
ESC : Esc

Figure 1-34 Sensor setup menu

4.Select source of ship's speed; STW (Speed-Through-Water): local sensor, SOG (Speed-Over-Ground): GPS.

5.Press ▲ twice to select SPD CALIB.

6.If speed reading is higher or lower than actual speed you may apply an offset to compensate for this. Enter offset with plus or

minus sign. The key alternately displays plus and minus.

7.If a water temperature sensor is installed, press ▼ to select

TEMP SENSOR.

8.Press tto select OWN. (NMEA is for water temperature data from external source.)

9.Press ▼ twice to select TEMP CALIB.

10.If temperature reading is higher or lower than actual tempera- ture you may apply an offset to compensate for this. Enter off-

set with plus or minus sign. The key alternately displays plus and minus.

11.Press ▼ to select DEPTH CALIB.

12.Enter ship's draft, if applicable. Normally, depth is measured from the transducer so enter positive figure.

13.Press the MENU key.

Autopilot or remote display connection

1.Press the MENU key.

2.Press the [0] key.

3.Press the [6] key.

1-24