8-1
SETTING DESTINATION

8.1 Setting Destination

The GP-1610CF offers four methods by which
you can set destination:
• Previously entered waypoint
• Cursor position
• Event position/MOB position
• Route
Setting destination by waypoint
1. Press the GOTO key. The following
menu appears.
SELECT GOTO MODE
WPT List
EVENT List
ROUTE List
Cursor/Route plan
ENT: Sel CLR: Release
ESC: Cancel
Figure 8-1 Destination waypoint
selection menu
2. Press the GOTO key again to select WPT
List.
3. Press the ENT key. The waypoint list ap-
pears.
: Cursor
ENT: Set
*: In Use
WAYPOINT LIST
No.
001
002
005
LAT/LONG COMMENT
23°00.000’N
123°00.000’E
10MAR97 01_ _
32°21.128’N
135°27.923’E
10MAR97 01_ _
30°12.345’N
127°21.293’E
10MAR97 01_ _
: Page change
CLR: Release
MENU: Sel Mode
Figure 8-2 Waypoint list
4. Operate ▲ or ▼ to select a waypoint.
5. Press the ENT key.
• A dashed light-blue line runs between des-
tination selected and own ship's position.
• The range and bearing to the destination
appear at the bottom of the display.
WP001 0° 10nm
CSE 10.0° SPD 16.8kt 2D
DEP 110m TMP 16.0°C 14:30
POS 34°26.345’N 135°41.232’E
Destination
Own ship’s
position
Course
Bearing and range
to destination
01
00
Figure 8-3 Appearance of display when
destination is selected by waypoint
Setting destination by cursor
1. Press the GOTO key.
2. Press the GOTO key to select Cursor/
Route plan.
3. Press the ENT key.
: Cursor
ENT: Set
ENT twice: complete
MENU: SEL Mode
4. Place cursor on position desired for des-
tination.
5. Press the ENT key. To set a single desti-
nation, go to step 7. To set more than one
destination, go to step 6.
6. Repeat steps 4 and 5 to enter other desti-
nations.
7. Press the ENT key.