Furuno GP-1610CF manual Demonstration Display, Memory Card Operations for technicians, Saving data

Data Rx: Shows DGPS beacon receiver is normal or abnormal. Two dashes appear when no DPGS beacon receiver is connected.

Ref Sta: Shows status of DPGS transmitting station. Two dashes appear when no DPGS beacon receiver is connected.

Program No.: Shows the program version number of the unit.

Rx Status: This section shows elevation angle, azimuth and signal levels of GPS sat- ellites.

14.7 Demonstration Display

The demonstration display provides simulated operation of this unit. Own ship tracks, at the speed selected, a figure eight course, starting from position entered. All controls are opera- tive; you may set destination, enter marks, operate the video sounder, etc.

1.Turn on the power while pressing and holding down the ENT key. Release hold of the keys when the following display appears.

DEMO SETTING

BASE POSITION

_ _ ° _ _ . _ _ _ ’N _ _ _ ° _ _ . _ _ _ ’E

SPEED:

00.0kt

: Cursor	: Column
ENT: Enter	: N/S, E/W

Figure 14-5 Demo setting screen

2.Key in latitude and longitude for base po-

sition. If necessary, press to switch from North latitude to South latitude or vice versa, or from West longitude to East longitude or vice versa.

3.Press ▼.

4.Enter ship's speed to use for the demon- stration.

5.Press the ENT key to start the demonstra- tion display. The unit checks itself for proper operation and then the plotter dis- play appears. DEMO and 3D (or 2D) are alternately displayed in the data window at the bottom of the screen when the unit is in the demonstration mode.

6.To return to the normal mode, turn off the power and then turn it on while pressing and holding down the ENT key.

Note: When the memory is cleared while in the demonstration mode, the unit starts up in the normal mode.

14.8Memory Card Operations (for technicians)

Before changing the internal battery, save the contents of the memory (waypoint, event, mark, track, route data and menu setting data) to a memory card (256 K bytes).

Saving data

1.Press the MENU key.

2.Press the [7] key to select MEMORY SAVE/LOAD.

3.Press ▲ to select SAVE MEMORY.

MEMORY SAVE/LOAD

SAVE MEMORY		NO	YES
LOAD MEMORY		NO	YES
: Cursor	: Go		ESC: Esc

Figure 14-6 Memory save/load menu

4. Press s to select YES.

Overwrite memory card.

ENT: YES

ESC: NO

14-6