4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for
Installation of beacon receiver
Procedure
1.Dismount chassis assembly from panel/chassis assembly by disconnecting the connector and PH8P from J8 on MAIN Board shown in the figure below.
Remove two ties
Chassis assembly
PH8P
Connector
Panel assembly
Dismounting chassis assembly
2.Dismount heat sink from chassis assembly by unfastening three screws on the ANLG board, loosening a screw at TR fixing plate and disconnecting the connector of the mini pin coax cable.
ANLG board | Screws (3 X 8), 3pcs. |
|
Mini pin coax cable
Heat sink
TR fixing plate
Chassis assembly
17
