4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for
Note: When reattaching the cover, confirm the following parts are attached.
•Inside of the cover: Shield gasket, GN gasket (See the figure below.)
•On ANLG Board: Connector gasket (See the page 16.)
GN gasket
Shield gaskets
Checking the beacon receiver
1.Press the [MENU] key.
2.Press the CONFIGURATION soft key.
3.Press the SYSTEM MENU soft key.
4.Press the SELF TEST soft key.
5.Press the MEMORY•I/O TEST soft key to display the following message.
TEST
PROGRAM:OK
NO.1418260XX
SRAM:OK
DRAM:OK
PORT1:OK*
PORT2:OK*
INTERNAL BATTERY: OK
GPS RECEIVER:OK
NO.48502370XX
BEACON RECEIVER:OK
NO.08501781XX
NO.
RETURN
*Special connections are required to check these ports. Otherwise,
Memory, I/O Test Display
6.Confirm that BEACON RECEIVER: OK is displayed.
7.Press the RETURN soft key.
8.Press the [PLOT] key to return the plotter display.
21
