Furuno GP-1850WF manual Changing Waypoint Data, Changing Waypoint Position on the Plotter Display

6.3Changing Waypoint Data

You can change the waypoint data through the waypoint list.

1.Press the [WPT/RTE] key, WAYPOINTS, and LOCAL LIST or ALPHA/NUMERIC LIST soft keys.

2.Press ▲ or ▼ to select the waypoint you want to change.

3.Press the EDIT WPT soft key.

4.Change data as you did in “Entering waypoints by the cursor.”

5.Press the SAVE soft key.

6. WAYPOINTS

6.4Changing Waypoint Position on the Plotter Display

You may change the position of waypoints on the plotter display as follows:

1.Press the [WPT/RTE] key followed by the WAYPOINTS soft key to open the WAYPOINTS menu.

2.Press the WAYPOINT BY CURSOR soft key. The plotter display appears.

3.Operate the cursor pad to place the cursor on the waypoint which you want to change. A flashing diamond mark appears on the waypoint when it is correctly selected.

4.Press the EDIT/MOVE soft key.

5.Press the MOVE WPT soft key.

6.Operate the cursor pad to place the cursor on the location desired.

7.Press the [ENTER] key.

The waypoint moves to the cursor position and its new position is recorded on the waypoint list. If the waypoint is set as destination or is part of a route, you are asked if you are sure to move the waypoint. In this case, press the [ENTER] key again to move the waypoint, or the [CLEAR] key to cancel move.

6-5