Furuno GP-1850WDF 11-12, UPLOAD/DOWNLOAD DATA menu, Upload/download menu, Display unit, rear view

11. CUSTOMIZING YOUR UNIT

UPLOAD/DOWNLOAD DATA menu

This menu allows you to upload waypoint and route data to a PC or download the same data from a PC, via the DGPS connector at the back of display unit. The menu can be displayed by pressing the [MENU] key followed by the CONFIGURATION and UPLOAD/DOWNLOAD DATA soft keys. For detailed information, see the Installation Manual.

DWNLOAD

UPLOAD

DOWNLOAD WPT/RTE TO PC

UPLOAD WPT/RTE FROM PC

SAVE DATA TO MEMORY CARD

LOAD DATA FROM MEMORY CARD

DGPS 3D RETURN

Upload/download menu

					+ GND
					1	3
						2
						-
ANT	XDR	TEMP/SPD	DGPS	NMEA	12	- 24
					VDC

Connect PC to DGPS.

Display unit, rear view

Set communication software on the PC as

follows:
Baud Rate:	4800 bps
Character Length:	8 bit
Stop bit:	1 bit
Parity:	None
X Control:	XON/XOFF

The following data can be downloaded/uploaded between a personal computer and this equipment:

•Waypoint data (In alphanumeric order)

•Route data (In order of route number)

•End of sentence

Note 1: There are two kinds of data for route data: route data and route comment data.

Note 2: DGPS position fix is not available when uploading or downloading data.

Download waypoint/route to PC

1.Connect the PC to the GP1850W series as shown on the next page.

2.Press the DOWNLOAD WPT/RTE TO PC soft key. You are asked if you are ready to download waypoints and routes.

3.Press the [ENTER] key to download.

Upload waypoint/route from PC

Note that all waypoint and route data stored in this unit will be deleted when data is uploaded.

1.Connect the PC to the GP-1850W series as shown below.

2.Press the UPLOAD WPT/RTE FROM PC soft key. You are asked if you are ready to upload waypoints and routes.

3.Press the [ENTER] key to upload.

11-12