12
Display
unit ID
3.4 Remote Controller Setting A remote controller can be set to be operative with a specific display unit, in the case of
multiple MU-170C display units. It is useful to label the display unit and the corresponding
remote controller with same name.
1. Press the MENU key to show the main menu.
2. Press the ► key to select SYSTEM.
SYSTEM menu
3. Press the ▼ key to select INFRARED REMOTE.
You may set the ID (identification code) of display unit and remote controller. There are
four codes in the ID; A, B, C and D.
4. Point the remote controller toward the optical sensor of the display unit, and press any
key on the remote controller. The current setting of the remote controller is shown inside
the remote controller ID square.
5. Press the RGB2 and BRILL + keys together on the remote controller to change the
remote controller ID. With each press of those keys, the remote controller ID switches
from A to D in turn and returns to A.
Your selection appears inside the square.
6. Press the ◄ or ► key to select the display unit ID so that it is the same as the remote
controller ID.
7. Press the MENU key to close the menu.
Remote controller ID square
RGB1 RGB2 DVI VIDEO1 VIDEO2 VIDEO3 OSD SYSTEM
INFRARED REMOTE
A
EXT BRILL CTRL OFF (OFF/ON)
DEFAULT RESET NO
INFORMATION
RGB1 : 1280x1024 fH: 80KHz fV: 75Hz
RGB2 : 640x480 fH: 31KHz fV: 60Hz
DVI : NO SIGNAL
VIDEO1: NTSC
VIDEO2: PAL
VIDEO3: NO SIGNAL
PROGRAM NO.: *****