Gaggia Syncrony Dispensing Steam - Cleaning And Maintenance, Switching from steam to coffee

Models: Syncrony

1 90
Download 90 pages 19.08 Kb
Page 25
Image 25
DISPENSING STEAM - CLEANING AND MAINTENANCE

DISPENSING STEAM - CLEANING AND MAINTENANCE

25

 

 

 

 

Before dispensing hot water, make sure that the green temperature ready light (24) remains lit.

When the machine is ready to dispense coffee, proceed as follows:

Place and cup and/or a receptacle beneath the hot water/steam tube (15).

9DISPENSING STEAM/MAKING CAPPUCCINO Turn the knob (17) counter-clockwise.

Dispense the desired amount of hot water; turn the knob (17) clockwise to cut off the flow of hot water. The machine returns to normal operating mode.

9DISPENSING STEAM/MAKING CAPPUCCINO

The steam may be used to froth milk for cappuccino and to heat other beverages.

Danger of scalding! Dispensing may be preceded by brief sprays of hot water. The dispensing tube can reach very high temperatures:

avoid touching it directly with your hands.

When the machine is ready to dispense coffee, press the button (27). The machine requires pre- heating.

Before dispensing steam, make sure that the green temperature ready light (28) remains lit.

Position the steam tube (15) over the drip tray and open the “hot water/steam” knob (17) for a few seconds to discharge residual water from the steam tube; soon only steam will issue from the tube.

Close the knob (17).

Fill the receptacle you want to use for making cappuccino 1/3 of the way with cold milk.

avoid touching it directly with your hands. To ensure best results when making receptacle are cold. cappuccino, make sure both the milk and

receptacle are cold.

9.1 Switching from steam to coffee Place the tip of the steam tube in the milk to be heated and open the knob (17); slowly raise the receptacle, with gentle rotating movements, to obtain an even layer of foam.

After dispensing the amount of steam desired, close the knob (17).

The same procedure may be used to heat other beverages.

After this operation, wipe the steam tube clean with a damp cloth.

9.1 Switching from steam to coffee

To dispense coffee you must press the but- ton (27).

When switching from dispensing steam to dis- pensing coffee, the pilot lights (24) and (28) flash simultaneously to indicate that the machine is overheated and cannot dispense coffee.

In order to dispense coffee, you must drain some water by turning the steam knob (17) until only the temperature ready pilot light (24) remains steadily lit.

10 CLEANING AND MAINTENANCE

Basic cleaning

Maintenance and cleaning may be carried out only when the machine is cold and disconnected from the power supply.

Do not immerge the machine in water and do not place any of its components in a dishwasher.

Do not use sharp objects or aggressive chemical products (solvents) for cleaning.

10 CLEANING AND MAINTENANCEManual backgroundManual backgroundManual background It is recommended that you clean the water container daily:

-Remove the filter (C) located inside the container, and rinse with clean drinking water.

-Return the filter (C) to its slot, pressing gently while turning slightly.

-Fill the container with fresh drinking water.

Manual background Use the brush provided to clean the ground coffee dispenser daily when in use:

Use a soft cloth moistened with water to clean the machine.

Do not dry the machine and/or its components in a microwave and/or conventional oven.

Manual background Clean the machine compartment and the dispensing unit, we recommend emptying out the dregs box (10) every day.

Page 25
Image 25
Gaggia Syncrony Dispensing Steam - Cleaning And Maintenance, Dispensing Steam/Making Cappuccino, receptacle are cold