OPERATING INSTRUCTIONS Continued
To set the oven temperature, press the SET key again. The TEMP LED will light and the oven temperature can be set by rotating the dial on the controller until the desired temperature is displayed. Pressing the SET key again will light the HOLD LED allowing the operator to set the hold temperature in the same manner.
NOTE: If the hold temperature is not set, the default hold temperature is °F (°C) or the last programmed temperature. (Hold temperature range is °F (°C) to °F (°C).
When the core temperature is reached the display will sound and flash “DONE” for seconds. Automatically, the display will switch to count “UP” the time the oven is on hold.
Setting Setback Feature
To set or change the setback settings, press and hold the SETBACK key for two seconds. The TEMP LED will light and a temperature will be displayed. Set the temperature using the dial, then press the SET key. The TEMP LED will go out and the TIME LED will light (“Time” is factory set at ). Set the time using the dial, then press the SET key. Press the SET key one more time to exit programming.
NOTE: To disable the setback function, set the time to zero.
Master 475 Electronic
Programmable Control
Manual Cooking
1. Press SET key – TEMP LED will light.
2. Set temperature using the dial (factory preset at 350°F).
3.Press SET key – FAN LED will light.
4.Select fan mode using one of the three (3) fan keys (HIGH, LOW, PULSE) – the selected FAN LED will light.
5.Press SET key – TIME LED will light.
Page 12 | Part # 1955203 (12/06) |
