Magnum 6K32F/FR/FC/FRC Managed Switch Installation and User Guide (05/08)
27
www Garre ttCom com
..
3.2 Connecting Ethernet Media
The Magnum 6K32F Series Switches are specifically designed to
support all standard Ethernet media types within a single Switch unit. This is
accomplished by using a family of different port Modules which can be
individually selected and configured per-port. See Section 2.4 for a description
of the PMs.
The various media types supported along with the corresponding IEEE
802.3 and 802.3u standards and connector types are as follows:
IEEE Standard Media Type Max. Distance Port Module
Fiber:
1000BASE-FX Multi-mode 220m ( ft) GBIC-SXSC
Single-mode 70km GBIC-ZXSC
100BASE-FX Multi-mode 2.0km (6,562 ft) 6KP6-RJMSC, -RJMST
Single-mode 18.0km (95K ft) -RJSSC, -RJSSCL
small form factor Multi-mode 2.0km (6,562 ft) 6KP8-MTRJ, -MLC
small form factor Single-mode 15 km 6KP8- SLC
Copper:
10BASE-T
100BASE-TX twisted pair 100m (328 ft) 6KP8-RJ45
1000BASE-TX twisted pair 100m (328 ft) GBIC-TP
3.2.1 Connecting Fiber Optic ST-type, “twist-lock”
The following procedure applies to installations using a PM with ST-type fiber
connectors. This procedure applies to ports using a 6K32F Series module, MST-
type port.
1. Before connecting the fiber optic cable, remove the protective dust caps from the
tips of the connectors on the PM. Save these dust caps for future use.
2. Wipe clean the ends of the dual connectors with a soft cloth or lint-free lens tissue
dampened in alcohol. Make certain the connectors are clean before connecting.
Note: One strand of the duplex fiber optic cable is coded using color
bands at regular intervals; you must use the color-coded strand on the
associated ports at each end of the fiber optic segment.
3. Connect the Transmit (TX) port (light colored post) on the Magnum PM to the
Receive (RX) port of the remote device. Begin with the color-coded strand of
the cable for this first TX-to-RX connection.