GarrettCom 6K8 manual Www . GarrettCom . com

Magnum 6K8-Series Industrial Field Switch Installation and User Guide 03/06)

face plate with 4 screws to complete the installation process for port module. The front panel screen plate does not need any screws to hold on port module, but need to place tightly and carefully while placing on LEDs.

Step 8. Once 6KPMV card have been installed (including faceplate and screen plate), the chassis cover should be replaced. Make sure the chassis top cover is aligned properly to the base before securely sliding the chassis base track inside the top cover properly as shown in

Fig 3.6.2h

Fig. 3.6.2h

sliding in the top cover onto the chassis base track

3.6.3Removing 6KPM Cards

To properly remove a 6KPM card from the 6K8-Series Industrial Field Switch, follow the 3 steps below.

Step 1. Remove chassis cover See procedures in Section 3.6.1 above.

Caution: Be sure the power cord is unplugged.

Step 2. Remove retaining screws placed on top of the 6KPMV and Face Plate

Each 6KPMV module is secured with nine retaining screws #440x3/8. These screws are used to secure a 6KPM card in position (see Figure 3.6.3a). Remove the 9 screws to take off the daughter module and thereafter three standoffs

www . GarrettCom . com

37