GarrettCom Powering the Magnum Quad-Series Switch, 10Mbps Fiber ports internal jumper settings

Magnum Quad-Series Fiber Switches Installation and User Guide (06/03)

Jumper Settings for 10Mb Fiber Half or Full

	Jumpe	Port	Functio	Factory	Spee
JF3	JF 1-2	PIN 1-	FDX @10Mb config	NO	10 Mb
JF3	JF2-4	Pin 2-4	HDX@10Mb	YE	10 Mb
JFD1	JP1-3	PIN 1-	FDX@10Mb config	NO	10M
JFD1	JP2-	PIN 2-	HDX @10Mb config	YE	10M
				10Mbps Full	10Mbps Half Duplex
	JFD		JFD	Duplex

	1	2	1	2
			3	4
Factory Settings	3	4
10Mbps Half-			10Mbps Full-
Duplex			Duplex

JFD

Jumper Settings for HDX/FDX

JF3	JF3	Factory Settings
1	2
10	10

Printed Circuit card Bottom QPM Retaining

Two(50) Pin

4PM Connectors (inserts into main board )

Jumper Settings for HDX/FDX

JF

1 2

34

5

Figure 3.7 10Mbps Fiber ports internal jumper settings.

Note: Be certain that the main power is disconnected before opening the unit or changing any internal jumper settings

3.8Powering the Magnum Quad-Series Switch

The Magnum Quad-Series Switches incorporate an internal universal power

supply, and has a recessed male IEC connector for the AC power cord at the left-rear. A manual power ON-OFF switch is adjacent. A six-foot 115 VAC 60 Hz standard power cord is supplied with each unit shipped within the United States and Canada.

110-220	ON
VAC

47-63Hz

1.0-0.5A OFF

Figure 3.5: Magnum Quad- Series AC power connector

The auto-ranging power supply supports installation environments where the AC voltage is from 90 to 260 volts with a power input frequency of between 47 and 63 Hz. The 8-port units will consume just under 20 watts of power typically, and the 16- port units will consume about 35 watts typically.

www . GarrettCom . com

24