When prompted, remove the diskette and turn off the server.
Place the startup diskette containing the BIOS files into drive A.

Chapter 5: Using the BIOS Setup Utility

Warning Moving the jumper while the power is on can damage your server. Always turn off the server and unplug the power cord and all other cables before changing the jumper.

4 Place the jumper across pins 5-6 of jumper J13.

Jumper pins 5-6

5 Close the case, then reconnect the power cord, monitor, and keyboard. For more information, see “Closing the server case” on page 28.

6

7 Turn on the server. At the start of the BIOS recovery process, the server beeps once. The recovery process may take a few minutes.

8

9 Disconnect the power cord and remove the side panel again. Remove the jumper from pins 5-6 of jumper J13, and place it over just one of the pins for storage.

10 Close the case, reconnect the power cord and all other cables, then turn on the server.

11 When the Gateway Logo screen appears, press F2 to open the BIOS Setup utility.

12 In the BIOS Setup utility, go to the appropriate menus and select any BIOS fields you want to change. Make sure that the date and time are correct.

13 Save your changes, then close the BIOS Setup utility.

58

www.gateway.com