Chapter 5: Using the BIOS Setup Utility

9

10

Close the case, then reconnect the power cord, monitor, and keyboard. For more information, see “Closing the server case” on page 28.

Turn on the server. A message appears saying that the CMOS Checksum is bad, which means the BIOS has been cleared successfully.

11 Press F2 to load the default BIOS values and open the BIOS Setup utility. All BIOS settings return to factory defaults, and all BIOS passwords are erased.

12

13

14

Turn off the server, disconnect the power cord, and remove the side panel again.

Remove the jumper from pins 3-4 of jumper J13 and place it over just one of the pins for storage.

Close the case, reconnect the cords, then turn on the server.

60

www.gateway.com