Page
Contents
Checking Out Your Gateway Server
Setting Up Your Server
Maintaining Your Server
Installing Components
Using the BIOS Setup Utility
Troubleshooting
Server Specifications
BIOS Settings
Safety, Regulatory, and Legal Information
Index
Page
Checking Out Your GatewayServer
Front
Back
System board
Getting Help
Page
Setting UpServerYour
Setting up the hardware
Protecting from power source problems
Starting your server
To start the server:
Page
Turning off your server
To turn off the server:
Setting up the operating system
Page
MaintainingServerYour
Caring for your server
Cleaning tips
Cleaning the keyboard
Cleaning the screen
Cleaning the tape drive
Preparing for system recovery
To record your BIOS configuration:
System administration
Using BIOS security passwords
To set the BIOS security passwords:
Option
Description
Using your Server Companion CD
ComponentsInstalling
Preparing to install components
Preventing static electricity discharge
Opening the server case
To open the server case:
Page
Closing the server case
To close the server case:
Installing drives
To install a CD, DVD, or diskette drive:
Page
Page
Page
Page
To install a hard drive:
Page
Page
Installing memory
To install or replace memory:
Installing PCI expansion cards
To replace, add, or reseat a PCI expansion card:
Page
Replacing the processor
To replace the processor:
Page
Page
Replacing the power supply
To replace the power supply:
Page
Replacing the system board
To replace the system board:
Page
Page
Replacing the case fan
To replace the case fan:
Page
Replacing the CMOS battery
To replace the battery:
Page
Page
Using the BIOS
Setup Utility
Opening the BIOS Setup utility
To open the BIOS Setup utility:
Updating the BIOS
To update the BIOS:
To recover the BIOS:
Page
Resetting the BIOS
To reset the BIOS:
Page
Bypassing the BIOS passwords
To bypass the BIOS passwords:
Page
Troubleshooting
Telephone support
Telephone numbers
Tutoring and training
Safety guidelines
Error messages
Invalid partition table
Invalid password
Memory errors were detected while the system started up
Memory size error
Missing operating system
Troubleshooting
Beeps
Troubleshooting steps
The settings in the BIOS Setup utility are not retained
Your server does not recognize a CD, DVD, or the CD or DVD drive
Your CD or DVD drive tray does not open
The diskette drive is not recognized
The diskette drive LED is lit continuously
Your server does not recognize an expansion card
You receive a “Non-systemdisk” or “disk error” error message
Your server does not recognize an IDE drive
Your server does not recognize a SCSI drive
To repair the master boot record:
To download the GWScan utility:
Liquid has been spilled into the keyboard
Memory errors were detected during server start up
Your modem does not dial or does not connect
To check the dialing properties in Windows:
The modem is not recognized by your server
Your server is running but there is no picture
The color is not uniform
A horizontal line or wire is visible across the monitor screen
You press the power button, but the server does not turn on
When you turn on the server, it makes several short beeps
Your server does not recognize a new processor
SpecificationsServer A
System specifications
System board specifications
Voltage
Fan
Temperature Type
Environmental specifications
Video specifications
Electronic specifications
Page
Page
Address Range (hex)
Amount
Function
Interrupt (IRQ)
PCI interrupt routing in PIC mode
PCI interrupt routing in APIC mode
Page
Additional specifications
Page
BIOS Settings
To view all BIOS settings:
BIOS menu
BIOS submenu
Setting
Value
Page
Page
Page
Page
Safety, C
Regulatory, and
Legal Information
Important safety information
Care during use
Replacement parts and accessories
Regulatory compliance statements
Industry Canada (IC)
Unintentional emitter per ICES-003
Page
Laser safety statement
Notices
Page
Index
CD or DVD drive
USB ports