Gateway ALR 9000 Installation Problems, Table 6:

Installation Problems

Table 6:

Problem	Probable Cause	Solution(s)
A drive is not rec-	The BIOS Setup program	Enter the BIOS Setup program
ognized by the	reflects the wrong parame-	and enter the appropriate
system.	ters.	parameters for the device.
	The device is not format-	Format the drive.
	ted.
	The device controller is not	Check jumpers and cable con-
	configured properly.	nections.
Memory errors	Memory was added or	Enter BIOS Setup and save the
were detected	removed and the new con-	new memory configuration.
during the power-	figuration was not saved in
up sequence.	BIOS Setup.
	A memory DIMM was	Check the DIMMs for proper
	installed incorrectly.	installation.
	A memory DIMM is not	Replace the faulty DIMM.
	functioning properly.
An adapter card	The interrupt and/or I/O	Check the address configura-
is not recognized	address is set incorrectly.	tion of the adapter card and
by the system.		ensure it does not conflict with
		another card in the system.
The Power LED is	ECC memory failure has	Press the Keyboard Inhibit
flashing.	occurred.	Switch IN and then OUT.
		NOTE: If the Keyboard Inhibit
		Switch is already in locked posi-
		tion (IN), you must first unlock it
		(OUT) and then lock it back (IN)
		to reset the ECC memory status
		and the Power LED.
The Power LED	A DIMM was incorrectly	Check the DIMM for proper
continues to flash	installed.	installation
after ECC reset.
	A DIMM is not functioning	Replace the faulty DIMM.
	properly.

Common Problems 41