CHAPTER 2: Getting Started
2Assemble the left and right chassis latches using the special chassis latch screws. Make sure that the latch is orientated as shown in the following illustration, with the spring arm located against its stop (on the right side at the top, on the left side at the bottom).
3Assemble the rack brackets to the rack posts as follows:
aFit the location pin at the back of the rail into the rear rail post.
bExtend the rail to fit between the front and rear rack posts.
cAttach the rail to both the front and rear of the rack using the washers and screws supplied. The screws should be left loose enough to allow for sideways movement of the rail.
dTighten the two clamping screws located on the inside of the rear section of the rack bracket.
|
|
|
|
| Rear | rack post |
|
|
|
|
|
| |
Guide pin |
|
| Clamping screws | |||
|
|
|
|
|
|
|
|
| Rack | bracket |
|
|
|
|
| |||||
Guide pin
Slide washer
Phillips screw
Front rack post
Square hole rack | Tapped hole rack |
Remove the nut when you use tapped hole rack posts.
20