www.gateway.com

4Mount the enclosure in the rack as follows:

aLift the enclosure and align it with the rack rails.

bCarefully insert the chassis slides into the rack rails and push it fully into the cabinet.

cTighten the rear screws.

dWithdraw the enclosure until it reaches the hard stops (approximately 15.75 inches (400 mm)).

eReturn the enclosure to the fully installed position and attach to the rack using the captive thumbscrews on the front flanges.

Module installation

The enclosure comes fully populated with all plug-in modules installed. For information on removal or replacement of plug-in modules, see “Troubleshooting” on page 11.

Enclosure configuration

Enclosures are configured with one internal domain of 12 drives per controller module.

Enclosure cabling - single enclosure

The RAID controller module provides bi-directional connection between the host-side interface and the drives. The drives will not be presented to the Host until they are configured and mapped by the controller.

21