Gateway EC18T manual Security, Parameter Description Option, Clear or Set, Enabled or

Security

The Security screen contains parameters that help safeguard and protect your computer from unauthorized use.

		InsydelH20 Setup Utility		Rev. 3.5
Information	Main	Security	Boot	Exit

Supervisor Password Is :	Clear
User Password Is :	Clear
HDD Password Is :	Clear
Set Supervisor Password
Set User Password
Set Hdd Password
Power on password	[Disabled]

Item Specific Help

Install or Change the password and the length of password must be greater than one word.

F1	Help	Select	Item	F5/F6	Change	Values	F9	Setup	Default
Es c	Exit	Select	Menu	Enter	Select	Sub-Menu	F10	Save	and Exit

The table below describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings.

Parameter	Description	Option
Supervisor Password Is	Shows the setting of the Supervisor password	Clear or Set
User Password Is	Shows the setting of the user password.	Clear or Set
Set Supervisor Password	Press Enter to set the supervisor password. When
	set, this password protects the BIOS Setup Utility
	from unauthorized access. The user can not either
	enter the Setup menu nor change the value of
	parameters.
Set User Password	Press Enter to set the user password. When user
	password is set, this password protects the BIOS
	Setup Utility from unauthorized access. The user can
	enter Setup menu only and does not have right to
	change the value of parameters.
Set Hdd Password	Enter HDD password.
Power on password	Defines whether a password is required or not while	Enabled or
	the events defined in this group happened. The	Disabled
	following sub-options are all requires the Supervisor
	password for changes and should be grayed out if the
	user password was used to enter setup.

NOTE: When you are prompted to enter a password, you have three tries before the system halts. Don’t forget your password. If you forget your password, you may have to return your notebook computer to your dealer to reset it.

26 Chapter 2