GE 200D8074P017 Set The Support Leg, Replace The Base Grille, Set The Controls

Installation Instructions

7SET THE SUPPORT LEG

Screw down the support leg until it touches the floor. This will prevent door misalignment.

8REPLACE THE BASE GRILLE

Replace the grille by installing the two Phillips head screws.

9SET THE CONTROLS

Set the controls to the recommended setting.

10START THE ICEMAKER

Set the icemaker power switch to the I (on) position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F (–9°C) or below. It will then begin operation automatically. It will take 2–3 days to fill the ice bin.

Power switch

NOTE:

In lower water pressure conditions, the water valve may turn on up to 3 times to deliver enough water to the icemaker.

31