GE 200D9366P016 operating instructions StandardNo Aesthetic Effects

Performance Data Sheet

SmartWater Filtration System

GSWF Cartridge

This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below.

The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/53.*

(100% safety factors built in for unmetered usage)

StandardNo. 42: Aesthetic Effects

Parameter	USEPA	Influent	InfluentChallenge	Effluent		% Reduction		Min. Required
	MCL	Average	Concentration	Average	Maximum	Average	Minimum	Reduction
Chlorine	—	1.845mg/L	2.0 mg/L+10%	< 0.05mg/L	0.05mg/L	> 97.29%	96.43%	> 50%
T & O	—	—	—	—	—	—	—	—
Particulate**	—	143,333#/mL	at least 10,000 particles/mL	29.83#/mL	140 #/mL	99.98%	99.91%	> 85%

StandardNo. 53: HealthEffects

Parameter	USEPA	Influent	Influent Challenge	Effluent		% Reduction		Min. Required
	MCL	Average	Concentration	Average	Maximum	Average	Minimum	Reduction
Turbidity	1 NTU***	10.3NTU***	1+1 NTU***	0.106NTU	0.14NTU	98.97%	98.61%	0.5 NTU
Cysts	99.95% Reduction	200,000#/L	Minimum 50,000 L	0	0	> 99.99%	> 99.99%	> 99.95%
Leadat pH 6.5	0.015mg/L	0.15mg/L	0.15mg/L+10%	< 0.001mg/L	< 0.001mg/L	> 99.33%	> 99.33%	0.010mg/L
Leadat pH 8.5	0.015mg/L	0.14mg/L	0.15mg/L+10%	0.001mg/L	0.003mg/L	> 99.29%	97.86%	0.010mg/L
Lindane	0.0002mg/L	0.0216mg/L	0.002mg/L+10%	< 0.00002 mg/L	< 0.00002mg/L	99.07%	98.75%	0.0002mg/L
Atrazine	0.003 mg/L	0.008mg/L	0.009mg/L+10%	< 0.002mg/L	< 0.002mg/L	> 76.12%	> 66.67%	0.003mg/L

*Tested using a flow rate of 0.5 gpm; pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 68° ± 5°F (20° ± 3°C) ** Measurement in Particles/ml. Particles used were 0.5-1 microns

*** NTU=Nephelometric Turbidity units

Operating Specifications

■Capacity:certified for up to 750 gallons (2,838 l); up to six months

■Pressure requirement: 40–120 psi (2.8–8.2 bar)

■Temperature: 33–100ºF (0.6–38ºC)

■Flow rate: 0.5 gpm (1.9 lpm)

General Installation/Operation/Maintenance Requirements

■Flush new cartridge at full flow for 3 minutes to purge out trapped air.

■Replace cartridge when flow becomes too slow.

Special Notices

■Installation instructions, parts and service availability, and standard warranty are included with the product when shipped.

■This drinking water system must be maintained according to manufacturer’s instructions, including replacement of filter cartridges.

■Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.

■The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.

■Check for compliance with the state and local laws and regulations.

■Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Systems must be installed and operated in accordance with manufacturer’s recommended procedures and guidelines.

System tested and certified by NSF International against Standard 42 for the reduction of chlorine, taste and odor, particulate Class I and Standard 53 for the reduction of cyst, lead, Lindane, Atrazine and turbidity.

NSF®

Manufactured for: General Electric Company, Louisville, KY 40225

44