Installation Instructions

REMOVING THE FREEZER DRAWER (on some models)
The freezer drawer can be removed, if needed, to fit through tight areas.

Read these instructions completely and carefully.

1REMOVE THE BASKETAOpen the freezer drawer until it stops.BLift the freezer caddy up.

CPull the divider forward until the rear locating tabs are out of the slots. Turn the divider slightly to the side to release the front locating tabs and lift out.

DThe freezer basket rests on the metal slide brackets and is held in place with swing locks.

ETurn the swing locks from vertical to horizontal position. Open refrigerator doors.

FLift the basket up and rotate it toward you. Slide out from the side of the drawer.

A

2REMOVE THE DRAWER FRONT FROM THE SLIDESARemove the hex-head screw from each side of the rail assembly.BTilt the drawer front toward the refrigerator and lift out.

Rail assembly

Screw

CSet the drawer front on a non-scratching surface.DPush the rail assemblies back into the cabinet.
TOP DRAWER (on Double Drawer Models)

1REMOVE THE BASKET

AOpen the freezer drawer until it stops.

BCut the 2 wire ties off of the basket with wire cutters.

CLift the front end of the basket so that the front two alignment tabs come out of the metal slide brackets first.

DThen rotate the front edge of the drawer up while lifting the remaining two rear alignment tabs out of the metal slide brackets. Pull the basket up and out of the drawer.

2REMOVE THE DRAWER FRONT FROM THE SLIDES

ARemove the 8 hex head screws from the drawer and remove the drawer.

 

B

Set the drawer front on a non-scratching

26

 

surface.

C

Push the rail assemblies back into the cabinet.