Tips On Learning, cont.
Tips On Learning, cont.
m. If learning the first or second buttons for a Mode results in continuous errors then try the following:
i.End the Learn session by pressing the EXIT button.
ii.Clear out the learned commands for that Mode.
iii.Check the IR transmitters are correctly aligned between the two remotes.
iv.Adjust the distance between the two remotes to be closer (e.g. half an inch) or a further away (e.g. 2 inches) from each other.
v.Try learning the original remote for that Mode again.
If problems reoccur with the same button check the original remote button being learned – does it transmit? Does it operate the target device? Try learning that button under a different clear Mode. If it learns okay then it is likely to be a different code type from the others and cannot be learned under the same Mode.
Learning Notes
1.You cannot learn under the Setup button.
2.All learned commands for a Mode are deleted if the same or a new
3.The Backlighting is turned off for Learning.
17
