GE 268, 263 manual Level II Programming, Conditioner Operation Type, Setting the Calendar Override

Level II Programming

Level II program parameters are those parameters used to fine-tune a conditioners operation. These are accessible by pressing and holding the UP and DOWN buttons until the display goes blank. Then release the buttons. Calendar Override is the first Level II parameter displayed. Level II program parameters include:

268 Conditioner Operation Type	263 Filter Operation Type
CALENDAR OVERRIDE	CALENDAR OVERRIDE
SALT AMOUNT	REGEN SU
CAPACITY K GRAIN	REGEN MO
HARDNESS GPG	REGEN TU
SELECT LANGUAGE	REGEN WE
CLOCK MODE	REGEN TH
UNITS OF MEASURE	REGEN FR
INJECTOR SELECTION*	REGEN SA
BACKWASH 1	CAPACITY GAL
SLOW RINSE	SELECT LANGUAGE
FAST RINSE 1	CLOCK MODE
BACKWASH 2	UNITS OF MEASURE
FAST RINSE 2	BACKWASH
OPERATION TYPE 268*	FAST RINSE
SERVICE INTERVAL	OPERATION TYPE 263*
CHLORINE GENERATOR	SERVICE INTERVAL
	CHLORINE GENERATOR
*View only.

Level II parameters will, in almost all cases, be preset to meet your configuration needs. The predefined system number will preprogram all of the Level II parameters to the selected default values.

•Setting the Calendar Override

Calendar Override allows the programmer to set the maximum days between regenerations. A setting of 0 (zero) means the calendar override is disabled. To change the calendar override, press the SET button while the words “CALENDAR OVERRIDE" appear on the banner display. The blinking digit can be changed to the desired numbers of days. To lock in the parameter, press the SET button.

WARNING: Setting days between regeneration to zero will cause the system to not regenerate. This setting is used for selecting regeneration on specific days or to use with a remote regeneration input. See below.

28	Level II Programming
Rev A