Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information
About the ice and water dispenser.
On some models
To Use the Dispenser
| Press the rim of the glass gently against the dispenser pad. |
| Set the selector switch to CUBES, CRUSHED ICE (on some |
| models) or WATER. |
| The spill shelf is not |
| spotting, the shelf and its grille should be cleaned |
| regularly. |
Spill Shelf | If no water is dispensed when the refrigerator is first installed, there |
| may be air in the water line system. Press the dispenser pad for at |
| least two minutes to remove trapped air from the water line and to |
| fill the water system. To flush out impurities in the water line, throw |
| away the first six glassfuls of water. |
A light switch (on some models) turns the night light in the dispenser on or off. The light also comes on when the dispenser pad is pressed. The light in the dispenser should be replaced with a 7 watt maximum bulb when it burns out.
CAUTION: Never put fingers or any other objects into the ice crusher discharge opening.
Ice Storage Bin
To remove:
Lift the center to free the bin from the shelf and pull the bin straight out while supporting it at front and rear.
| To replace: |
| Slide the bin back until the tab on the bin locks into the |
| slot on the shelf. If the bin does not go all the way back, |
Rotate | remove it and rotate the drive mechanism 1/4 turn. |
| Then push the bin back again. |
Drive
Mechanism
16
