GE 28, 30 owner manual Inserting the Door Panels, Installing the Handles

Inserting the Door Panels

Before installing the decorator panels, make sure they have been routed out in the proper areas as shown in the beginning of this section. Slide in the panels to perform a trial fit before fastening down the Handle and Top Trim.

Installing the Handles

Once the panels are fitted properly, install the Handle and Top Trim.

1	Slide the keyhole slots on the Handle down onto the buttons mounted to
	the face of the door. Slide the Handle downward until the bracket at the top
	of the Handle fits flush on the top of the door.
	Replace the two screws in the bracket that attach the Handle to the top of
2
	the Door and tighten the screws to 45 in-lbs torque.
	Replace the Top Trim making sure it fits over the Side Trim and that the
3
	locating tabs fit the inside of the Handle profile.
	Replace the Top Trim screws and tighten to 30 in-lbs torque.
4

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

31