GE PSHS6MGZSS, 49-60639, 200D8074P046 Replacing the light bulbs, Safety Instructions, Tips

Safety Instructions

Replacing the light bulbs.

Setting the controls to OFF does not remove power to the light circuit.

Reveal® appliance bulbs are used on some models. They can be identified by their blue color when they are not illuminated.

Not all features are on all models.

Your light shield will look like one of the following:

Refrigerator Compartment—Upper Light

Operating Instructions

Tabs

OR

Pocket

Unplug the refrigerator.

The bulbs are located at the top of

the compartment, inside the light shield. On some models, a screw at the front of the light shield will have to be removed. On other models,

the screw is located in the pocket located at the back of the light shield.

To remove the light shield, on some models, press in on the tabs on the sides of the shield and slide forward and out. On other models, just slide the shield forward and out.

After replacing the bulb with an appliance bulb of the same or lower wattage, replace the light shield and screws (on some models). When replacing the light shield, make sure that the tabs at the back

of the shield fit into the slots at

the back of the light shield housing. Plug the refrigerator back in.

Installation Instructions

Refrigerator Compartment—Lower Light

Tips

This light is located above the top drawer.

Unplug the refrigerator.

Remove the convertible meat drawer control knob by pulling straight out.

Lift the light shield up and pull it out.

After replacing the bulb with an appliance bulb of the same or lower wattage, replace the shield and the knob.

Plug the refrigerator back in.

Support Troubleshooting

Freezer Compartment

Unplug the refrigerator.

Remove the shelf just above the light shield. (The shelf will be easier to remove if it is emptied first.) On some models, a screw at the top of the light shield will need to be removed.

To remove the light shield, press in on the sides, and lift up and out.

Replace the bulb with an appliance bulb of the same or lower wattage, and reinstall the light shield. When reinstalling the light shield, make sure the top tabs snap securely into place. Replace the screw (on some models).

Reinstall the shelf and plug the refrigerator back in.

Consumer

Dispenser (on some models)

Unplug the refrigerator.

The bulb is located on the dispenser under the control panel. Remove the light bulb by turning it counterclockwise.

16

Replace the bulb with a bulb of the same size and wattage.

Plug the refrigerator back in.