GE 60-875 manual How to Use, Your, Touchpads, Remote Handheld Touchpad, Keychain Touchpad

	calling in a report to the central monitoring station or a pager, due to an action made by
	you or someone at the security system site.
How to Use
Your	Touchpads are used to control the security system from any location within or near your
Touchpads	home.
SYSTEM	Remote Handheld Touchpad
STATUS

ARM

Doors &

Windows

ARM

Motion

Sensors

DISARM

Interfacing with the system using a Remote Handheld Touchpad is similar to using the panel.

System Status

1 2 3

4 5 6

Press System Status once to hear information about your system from the panel. See “Status Beeps”.

ARM Doors & Windows

7 8 9

On Off

Press Arm Doors & Windows button once to turn the security system protection on for all protected doors and windows.

Press twice to eliminate the pre-programmed entry delay.

EMERGENCY- Press & Hold Both Keys

Note

Depending upon how your dealer programmed your panel, you may be required to enter your access code to arm the system.

ARM Motion Sensors

Press Arm Motion Sensors button once to turn protection on for all Motion Sensors. Use when no one is home. This is usually used in combination with ARM Doors & Windows. Press twice to activate the Latchkey feature.

Disarm

Press Disarm button once and enter your access code using the NUMERIC buttons to turn security protection off. To subdisarm the system, enter the master access code.

Subdisarm

Enter your master access code using the NUMERIC buttons while the system is dis- armed. Panel will announce, system disarmed. The Disarm button on the panel will begin to blink.

Emergency

Press both EMERGENCY buttons for 3 seconds to cause the system to call a central monitoring station to report a non-medical emergency.

Keychain Touchpad

For any keypress on the Keychain Touchpad, hold the button until the indicator light blinks.

If your installer programmed the Keychain Touchpad with no entry delay, and you armed the system with the Keychain Touchpad, you must disarm your system before entering the home to avoid causing an alarm.

If your installer programmed your system for Remote Touchpad Arming, you must enter your home to start the entry delay before you can use your Keychain Touchpad to disarm the system.

!To avoid causing false alarms, check with your installer on how your touchpad options are programmed

Warning ! Security system devices cannot compensate you for the loss of life

11 Simon Security System