Note
If there are no Special Motion Chime sensors in your system, the Chime Special Motion button can be used for Direct Bypassing and Unbypassing. See the
Arming Your System with Direct Bypassing and Arm- ing Your System with Direct Unbypassing sec- tions for more information.
Note
You can only use this feature if there is a Bypass button on your panel and there are no Special Motion Chime sensors in your system.
Note
You can only use this feature if there are no Special Motion Chime sensors in your system.
The Home Control buttons are used to monitor activity within and around the home. They are not used for intrusion protection. If any of the Home Control buttons are pressed and a sensor or module is not associated (programmed) with this feature the panel will announce, Function not available.
Chime Doors
Chime Doors is used to signal (chime) when a protected door is opened while the sys- tem is disarmed. The panel will announce the door that has been tripped and chime twice (ask your installer how this feature is programmed). This is a nice feature to use if you’re busy in one part of your home and you want to know when family members are going in and out of your home.
Turn Chime Doors on:
1.System must be disarmed. Press Chime Doors button.
Panel will announce, Chime on. Chime Doors button will be lit.
Turn Chime Doors off:
1.Press Chime Doors button
Panel will announce, Chime off. Chime Doors button no longer lit
Chime Special Motion
This is used to detect movement within a specific area. These Motion Sensors are not used for intrusion protection. The panel will chime three times and announce (see Option 41) the sensor that has been tripped. Use the same panel procedures as Chime Doors, except, with the Chime Special Motion button.
If you have Motion Sensors located in areas such as in a patio area or at the front door and you want to know when someone is approaching these areas, you would use this feature.
Direct Bypassing
Direct Bypassing refers to turning off (bypassing) certain sensors while the system is armed.
1.Press the Bypass button until you reach the sensor to be bypassed (sensor must currently be unbypassed).
2.Enter Master Code
Direct Unbypassing
Direct Unbypassing refers to turning on (reactivating) bypassed sensors while the sys- tem is armed.
1.Press the Bypass button until you reach the sensor to be unbypassed (sensor must currently be bypassed).
2.Enter Master Code. OR Change arming level.
Time Activated Lights
Turn on designated lights (with Lamp Modules) at a specific time. You can program what time the lights go on and off (see Programming - Light Control).
Turn Time Activated Lights on:
1.Press Time Lights button.
Panel will announce, time activated light on. Time Lights button will be lit.
Turn Time Activated Lights off:
1.Press Time Lights button.
Panel will announce, time activated light off. Time Lights button no longer lit.
Simon Security System | 6 |
