GE 60-875 manual Code, Home Control, Disarming Your System, Subdisarm Your System

Panel announces, Motions on, Latchkey on. Arm Motion Sensors light will blink and the exit delay will begin.

￿Disarming Your System

1.Upon reentering your home the entry delay will begin.

2.Status beeps will sound.

3.Enter your access code using the Code buttons.

Panel announces, System disarmed and the Disarm light will be lit.

!If you enter you home and you hear alarm sirens, or if controlled lights that should be off are on, an intruder may be inside or another emergency may have occurred. Leave immediately and call for help.

Warning

￿Subdisarm Your System

1.Enter your Master Access Code while the system is disarmed.

Panel announces, System disarmed. Disarm button light blinks and the system is sub- disarmed. When you’ve finished accessing the protected areas, press the Disarm button again. Panel announces, System disarmed. Disarm button light stops blinking. System is in Disarm mode.

If You Never Leave After Arming

Your panel can be programmed to recognize that you never left the premises. If you press the Arm Doors & Windows button and the Arm Motion Sensors button but don’t exit before the exit delay expires, the panel will not arm the motion sensors.

Check with your installer to find out if this feature is enabled for your panel.

If You Forgot Something After Arming

Your panel can be programmed to recognize when you leave the premises then quickly reenter. The panel will restart the exit delay to give you time to collect your things and leave again. You must leave before the exit delay expires or disarm the system. Ask your installer if this feature is enabled for your system.

Arming When the Panel Battery is Low

Your panel may be programmed so that you cannot arm the system if the panel battery is low. Ask your installer if this feature is enabled for your system.

CODE

1/2 3/4 5/6 7/8 9/0

CODE

There are 5 CODE buttons located in the second row of the panel. Each button repre- sents 2 numbers. The left CODE button is 1/2, which means that this button is pressed when entering either 1 or 2. For example, if your access code is 1-2-3-4you must press the 1/2 button twice and the 3/4 button twice to enter that access code. Access code lengths need to be between 3 and 6 digits and are set by the installer.

HOME CONTROL

Chime

Doors Motion Time Sensor On Of

HOME CONTROL

Bypass

Lights

5 Simon Security System