7 Error Messages
Error Code Error Message | Description |
162Cannot open fast Indicates current settings do not
sweep in this allow you to open fast sweep.
| case | For example, currently in FFT, |
|
| zero span, or any measurement |
|
| in power suite does not allow |
|
| fast sweep. |
156 | Incorrect | Indicates an invalid |
| alignment file | alignment file. |
| on flash |
|
153 | RF EEPROM | Indicates an error when writing |
| operate fail | alignment file. |
152Alignment file Indicates the alignment file has
| oversize | error or invalid data. |
151 | DSP boot fail | Indicates the analyzer |
|
| cannot process |
|
| measurement currently, |
|
| wait the analyzer to reboot. |
|
| If analyzer froze, try to restart |
|
| the analyzer. |
150 | Mixer overload | Indicates the first mixer in |
|
| danger. Either increase input |
|
| attenuation or decrease the input |
|
| signal level. |
149Mixer saturate Indicates you need to either increase the input attenuation or decrease the input signal level.
147 | Incorrect | Indicates invalid alignment data |
| alignment data | occurred. |
| in EEPROM |
|
143 | Final IF | Indicates you need to either |
| overload | increase the input attenuation or |
|
| decrease the input signal level. |
138USB device NOT Indicates the USB device is not
| ready | detected. |
136 | RBW limit to | Indicates the analyzer |
| 30 kHz when in | automatically couple the RBW to |
| fast sweep | 30 kHz when in fast sweep |
|
| mode. |
146 |
| N9340A User’s Guide |