Installation Instructions
Read these instructions completely and carefully; then follow step by step.
1 SELECT THE BEST LOCATION
A INDOOR UNIT |
• Do not allow any heat or steam near the unit . |
• Select a location where there are no obstacles |
in front of the unit . |
• Make sure that condensate drainage can be |
conveniently routed away. |
• Do not install near a doorway. |
• Ensure that the space around the left and right |
BOUTDOOR UNIT
•If an awning is built over the unit to prevent direct sunlight or rain exposure, make sure that heat radiation from the condenser is not restricted.
•Ensure that the space around the back and sides is more than 12″. The front of the unit should have more than 79″ of space.
of the unit is more than 6″. The unit should be |
installed as high on the wall as possible, allowing |
a minimum of 6″ from ceiling. |
• Use a stud finder to locate studs for mounting and |
to prevent unnecessary damage to the wall. |
• Install on studs and in a location from which |
the condensation water can be drained out |
conveniently and that permits easy connection |
with the outdoor unit . |
More than 12”
More than 79” 
More than 12”
The platform must
support a minimum of 200 lbs. See Installation Dimensions for mounting
hole spacing.
• Do not cover the inlet and outlet so that the |
outflow air can reach all parts of the room. |
• Install in a location that is strong enough to |
withstand the full weight and vibration of the unit . |
• Be sure that the installation conforms to the |
installation dimension diagram. |
• Leave enough space to allow access for routine |
maintenance. The height of the installed location |
should be 79″ or more away from the floor. |
• Install in a location that is 3 ft . or more away from |
other electrical appliances, such as televisions and |
audio devices. |
• Select a location that gives you easy access to |
remove and clean the filter. |
| More than 6” |
More | More |
than 6” | than 6” |
More than 79”
•Install in a location that is strong enough to permit safe installation and to withstand the full weight and vibration of the unit .
•Construct and anchor a strong and level mounting base or pad for the outdoor unit .
•Anchor the outdoor unit through its four mounts, using bolts.
•Select a location from which noise and outflow air emitted by the unit will not inconvenience neighbors.
•In humid locations, the unit may sweat and condensation (water) may drip from it . Take this into consideration when choosing the location.
•Select a location that has sufficient ventilation.
•Do not cover the inlet and outlet .
•Install unit away from flammable gas or corrosive gas leaks.
•Be sure the installation conforms to the installation dimension diagram.
•Rooftop Installations:
If the outdoor unit is installed on a roof structure, be sure to level the unit . Ensure the roof structure and anchoring method are adequate for the unit location. Consult local codes regarding rooftop mounting.
10
