GEAppliances.com

COOL MODE

Safety

RemoteControl

1.Press COOLpad.

2.Press LOW, MEDor HIGHpads to set desired fan speed.

3.Press the INCREASE+ /DECREASE– pads to set the desired temperature 60°F to 85°F in 1°F increments.

ControlPanel

1.Press the MODEpad until the COOLindicator light is lit and the LOW, MEDor HIGHindicator light is lit for the desired fan speed.

2.Press the INCREASE+/DECREASE–pads to set the desired temperature 60°F to 85°F in 1°F increments.

A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler.

Set the thermostat at a higher number and the indoor air will become warmer.

NOTE:If the air conditioner is off and is then turned on while set to COOL, it will take approximately 3 minutes for the compressor to start and cooling to begin.

CoolingDescriptions

ForNormalCooling—Select the COOLmode and HIGH or MEDfan with a middle set temperature.

ForMaximumCooling—Select the COOLmode and HIGHfan with a lower set temperature.

ForQuieterandNighttimeCooling—Select the COOL mode and LOWfan with a middle set temperature.

NOTE:IfyouswitchfromaCOOLsettingtoOFForto afansetting,waitatleast3minutesbeforeswitching backtoaCOOLsetting.

and Care Instructions Operating Instructions
FAN MODE

Use the FANmode to provide air circulation and filtering without cooling. Since fan-only settings do not provide cooling, a temperature setting will not be displayed.

RemoteControl

Press FANpad. Press LOW, MEDor HIGHpads to set desired fan speed.

ControlPanel

Press the MODEpad until the FANindicator light is lit and the LOW, MEDor HIGHindicator light is lit for the desired fan speed.

Support Consumer Tips Troubleshooting InstructionsInstallation Cleaning

5