1. Type
Drive Series
F V R F 2 5 C 9 S 7 U X
Power Series: 200V UX Series Applicable motor output (Hp)
3. Warning and Caution
Improper wiring will result in damage to, and failure of the unit. Please carefully note the items listed below, and use the unit as indi- cated.
2.Phase: 1AC -
3.Voltage range: 220V - 240V AC200V Series
4.Frequency: 50/60Hz
5.Rated output capacity
6.Rated output current
7.Output frequency range: 1- 120 Hz
8.Serial No.
2. Part Names
4
2
PRG | RUN | |
RESET | ||
| ||
FUNC | STOP | |
DATA | ||
|
3
1
WARNING AND CAUTION
1. | Do not connect the power supply to |
| voltage that exceeds the standard speci- |
| fication voltage with permissible fluctua- |
| tion. (Permissible voltage: AC220V - |
| 240V) |
2. | Do not connect power supply to the drive |
| output terminals (U, V, W). Connect |
| power supply only to the power terminals |
| (L1, L2) |
3. | Whenever removing the drive cover, |
| always switch off the power supply. Do |
| not switch on the power supply to the |
| drive with the drive cover removed. |
4. | Do not touch the live part until the CRG |
| lamp located above the main circuit |
| terminals goes out. |
5. | Avoid using a magnetic contactor (ON/ |
| OFF) installed in the line side of the drive |
| for RUN and STOP. Use the |
| (forward) and |
| for RUN and STOP. |
6. | Do not connect a power factor correcting |
| capacitor to the output side of the drive. |
7. | Do not perform a megger test between |
| the drive terminals or on the control |
CLOSED
1.Drive Cover
2.Keypad Panel
3.Frequency Setting VR
4.Mounting Screw Holes
5.Drive Cover Screw
OPEN
4
5
circuit terminals. |
7
