Installation Instructions
2CONNECTING THE WATER HEATER TO THE GAS SUPPLY
Connect the gas supply to the system following state and local plumbing codes. Use the supplied ball valve at the inlet to the system. Make sure the gas supply line to the water heater fits in the diagram shown on page 9. This is essential if a pipe cover accessory (model number AGTPCM) is to be installed.
IMPORTANT: Use a pipe wrench to securely hold on to the end of the water heater gas inlet to prevent twisting the inlet.
IMPORTANT: Leave the gas valve off until instructed to turn it on.
Gas Pressure Test Port
Gas Shut Off Valve
Gas Supply 
13
