After each use,clean the range top
and surface unit reflectors. CAU-
TION: Be sure all controls are
turned OFF and all surfaces are
cool before attempting to clean the
range top or surface unit reflectors.
1. To clean the range top, wipe
around the edges of the surface
unit opening in the range top.
Clean the area below the unit.
Rinse all washed areas with a
damp cloth or sponge.
2. To clean surface unit reflectors,
remove the surface unit. TO RE-
MOVE, raise the unit coil opposite
the receptacle. Lift about one inch
above the trim ring and pull away
from the receptacle. CAUTION: Be
sure the coils are cool before re-
moving asurface unit.
When the surface unit has been
removed, lift the chrome-plated
reflector pan/ring to clean under
the unit. Clean the reflector pans in
the dishwasher or asrecommended
on the cleaning chart. DO NOT use
ametallic scouring pad or steel
woo! as they may scratch the
chrome-plated surface of the re-
flector pan.
Your Care —
—
Proper care and cleaning are important so your Range —
will give you efficient and satisfactory service. Follow
these directions carefully in caring for your range to
assure safe and proper maintenance,
ig)ow?rw?nt
~Surface Units
3. This range is equipped with a
lift-up cooktop for your cleaning
convenience. With the cooktop
raised, you can clean the area
beneath the surface. (Be sure Ml
controls are turned OFF before
a#ternptingto Mthe moktop.)
When raising or lowering the
cooktop, be sure not to drop or
force the cooktop, asthe porcelain
finish may become chipped or
otherwise damaged.
To lift the cooktop proceed
as follows:
Remove all utensils and other
items which may slide OFF the
cooktop.
With both hands grasp the front
edge of the cooktop.
Lift the cooktop.
Raise the support rod and let the
cooktop rest on it.
To lower the cooktop:
@Lift the cooktop and lower the
support rod.
@Lower the cooktop and a!low it
to lock into position.
To replace the surface unit: ~
Place the chrome-plated reflector
pan and ring in the surface unit —
cavity found on top of the range.
Line up the reflector pan so the
unit receptacle can be seen.
Insert the terminals of the plug-in
unit through the opening in the
chrome-plated pan and ring and
into the receptacle.
Guide the surface unit into place
so it fits evenly and fits snugly into
reflector pan.
16