Do not attempt to clean plug-in
surface units in an automatic
dishwasher.
Do not immerse plug-in surface
units in liquids of any kind.
Do not bend the plug-in surface
unit plug terminals.
Do not attempt to clean, adjust
or in any way-repair the plug-in
receptacle.
The area under the bottom drawer
can be reached easily for cleaning
by removing the bottom drawer.
To remove, pull drawer out all the
way, tilt up the front and remove it.
To replace, insert glides at back
of drawer beyond stop on range
glides. Lift drawer if necessary to
insert easily. Let front of drawer
down, then push in to close.
ihe porcelain enamel finish is
sturdy but breakable if misused.
—This finish is acid reSiStant. tiOW-
‘-~-any acid foods spilled (such:---,
‘as fruit juices, tomato, or vinegar)
should not be permitted to remain
on the finish.
Light
Models JCS57, JCS67, &JCP67
are equipped with afluorescent
bulb that illuminates the back-
splash. Simply press backsplash
light switch and hold for ON. Press
again for OFF.
To replace the lamp located in the
backsplash, do the following:
Step ~: Remove the four screws
that hold the cover in position.
(Two are located on top of the
backsplash and two are located
under the backsplash overhang. )
Step 2: Lift the cover away and
twist out the fluorescent lamp.
CAUTiON: Be sure lamp is cool
~=f,~reremoving.
—
..=,-
Step 3: Insert the new fluorescent
lamp and twist into lock position,
(Check to make sure new lamp
operates. If not, lamp may be
blown.)
Step 4: Replace backsplash cover
and reinsert the screws that hold it
in position.
The oven lamp hasaglass lens held
in placewith aspring wire to protect
the oven lamp from the heat of the
oven.
CAUTION: Before replacing your
oven bulb, disconnect the elec-
trical power for your range at the
main fuse or circuit breaker panel
or pull plug. Besure to let the lamp
cover and bulb cool completely
before removing or rep!acing.
TOREMOVE lamp bulb:
1.Swing wire to side and hold.
2. Lift off glasslens.
3. Removebulb.
TO REPLACElamp bulb:
1. Insert anew 40 watt appliance
bulb.
2. Replacelens over socket.
3. Swing wire over glass lens.
4. Reconnect electrical power to
range.
The glass lens must be iri place
wheneverthe oven is in use.
ToREMOVE door, open to first stop
position where you feel hinge catch
slightly. Place hands under each
end of door handle; lift door up and
away from hinges.
To REPLACE, place hands under
each end of door handle, or on
sides of door. Resting door against
knee, slip hinge arms into door
slots. Push door in at bottom un~il
it clicks.
.-