E
CONVERTING
SURFACE BURNERS
ON
MODELS EQUIPPED WITH SEALED BURNERS
(See
Step
4 if
range is equipped with standard
twinburnersj
‘urnercap~
1. Remove the grates, burner caps and burner
heads.
2. Using the
torxdriver,
remove the burner bases
by unscrewing the 3 small screws in each base.
~
the burner straight out.
DO
N~
disconnect the wires from the burner
bases unless the
cooktop
needs to be raised.
3. Remove the brass
ofice
spud under each
burner base by unscrewing spud from fitting
with a
7mm
or small adjustable wrench
(depending on the size of your spuds). Apply a
3/4” wrench to the hex on the gas inlet tube
as a back-up when removing spud to prevent
the aluminum
horn
twisting.
4. Install orifice spuds according to one of
the following diagrams (see
❑
or
❑
) for
LP
gas or natural gas, depending on
whicfi
you are
converting to.
❑
Orifice
Spuds for Converting to
1P
Gas:
LP
orifice spuds are in a small
plastic~a~acked
with this Use and Care Guide.
LP
orifice spuds
have a 2-digit number and the letter “L” on one
side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on the
range where it is to be installed as shown below.
❑
OrifiCeSpudsfor
Converting to
Hatural
Gas:
Natural gas or~lce spuds have a 3-digit number
on one side. Each
orflce
spud will also have 1, 2
or 3 grooves on one side, with the letter “N”
underneath denoting the location on the range
where it is to be installed as shown below.
Front of Range
(continued next page)
41