Installation Instructions
E
Cooktop Burners cont.
E3 The Burner Flames (cont.)
Burners should be checked frequently
Check the inner cone of the flame. It should be about 11/16″ long.
Inner Cone |
|
of Flame | 11/16" |
Cooktop
Burner
If the flame size is not the right length, the flame adjustment screw must be adjusted. To access the flame adjustment screw, remove the control knob for the burner needing adjustment. Insert a flat blade screwdriver through the shaft of the valve. To increase the flame length, rotate the screw counterclockwise. To decrease the flame length, rotate the screw clockwise.
WARNING: If you attempt to measure the inner cone of the flame, please use caution. Burns could result.
E4 Removing the Shipping Screws
Grasp the sides of the cooktop and lift up. Remove the shipping screws from each of the four burner assemblies.
The shipping screw will be located at the end of each burner. 
This location is the ignitor bracket.
DO NOT REMOVE THE SCREWS HOLDING THE BRACKET.
DO NOT REMOVE THE SCREWS HOLDING THE IGNITOR BRACKET!
23
