GE JHC56G manual To Reposition SurfaceUnit, Adjusting Oven Thermostat

Plug-h surfaceunits To replace:

	—.—
	—.
	—
	— .——
	~
	—.
PULL KNOB OFF OF SHAFT,	—
	—–

Cleanthe area under the drip pans often. Built-up soil, especially grease, may catch fire. To make cleaning easier, the plug-in surface units are removable.

I RECEPTACLEMEDALLION

TERMINALS	I	CHROi4E-PLATED
I	SPIOER	DRIPPAN/RING

@Place the drip pan/ring in the surface unit cavity found on top of the range. Line up the drip pan so the unit receptacle can be seen.

@Insert the terminals of the plug- in unit through the opening in the pan/ring and into the receptacle,

@Guide the surface unit into place so it fits evenly and fits snugly into drip pan or trim ring.

Note: If your range has separate trim rings, the drip pan must be under the trim ring.

CAUTION

LOOK AT BACK OF KNOB AND
NOTE CURRENT SETTING,	——-—
BEFORE MAKING ANY
ADJ US’TMENT.
To increase temperature, turn
toward HI or RAISE; to decrease
turn toward LO or LOWER, Each
notch changes temperature 10-
degrees. Temperature can be raised
by 20 degrees or lowered by 30
degrees.

I	/’	e Do not attempt to clean plug-in
	//-	I surfaceunits in an automatic
	R	dishwasher.
		e Do not immerse plug-in surface
		units in liquids of any kind.

RIN

To clean:

*Wipe around the edges of the surfaceunit opening in the range top. Clean the area below the unit. Rinse all washed areas with a damp cloth or sponge.

Caution: Be sure all controls are turned OFF before attempting to clean under the cooktop or re- moving the Calrod@units,

To remove:

*Raise the unit coil opposite the receptacle. Lift about one inch above the trim ring and pull away from the receptacle. Caution: Be sure the coils are cool before re- moving a Calrod@ unit.

@After removing the plug-in sur- face unit, lift the drip pan/ring to clean under the unit.

gDo not bend the plug-in surface unit plug terminals.

@Do not attempt to clean, adjust or in any way repair the plug-in receptacle.

To Reposition SurfaceUnit:

oReplace drip pan into recess in cooktop.

ePut trim ring in place over drip pan.

*Guide the surface unit into place so it fits evenly into trim ring. Pan mustbe under trim ring.

Adjusting Oven Thermostat

Use time given on recipe when cooking first time. Oven thermo- stats, in time, may “drift” from the factory setting and differences in timing between an old and a new oven of 5 to 10 minutes are not unusual, Your oven has been set correctly at the factory and is more apt to be accurate than the oven which it replaced. However, if you find that your foods consistently brown too little or too much, you ma}fmake a simple adjustment in the thermostat (Oven Tcmp) knob,

1.Pull off knob, loosen both screws on back of knob holding skirt of knob firmly. 2. Turn black handle to move pointer one notch in desired direction. Tighten screws.

3.Return knob to range, matching flat area of knob to shaft. Recheck oven performance before making an additional adjustment.

—-.—. —

15