Installation Instructions
TOOLS AND MATERIALS
REQUIRED (NOT SUPPLIED)
Pencil and | Phillips and | Duct tape |
tape measure | Flat blade screwdrivers |
|
REMOVE THE PACKAGING
•Remove parts package from the “V” shaped cardboard insert. Remove insert. Remove shipping pads.
•Lift the hood out of the box.
CAUTION: Lift hood by grasping the outside edges of the exhaust opening on the top. Do not
lift hood by the exhaust opening divider – damage will occur!
Electric drill with 1/8″ and 3/8″ bits
Spirit level
Flashlight
Pliers
Wire Cutter/
Stripper
Ladder
1/4″ pivoting hex socket
Safety glasses
UL Listed Wire nuts
Hammer | Metal Snips |
|
Saber saw or Key Hole Saw
Allen
Wrench
|
| Parts |
|
| Package |
Wood |
|
|
Mounting | Duct | Hood |
Support | Transition | |
|
| Motor |
|
| Mounted |
|
| on Skid |
Shipping Carton
•Remove transition duct piece from the inside of the hood. Discard screws.
•The vent hood motor is shipped secured to the skid with 4 screws. Locate and remove 2 screws on each side of the motor. Discard the shipping skid.
Hold Down Screws
Hold Down Screws
• From the inside of the hood, remove shipping screws |
holding the wood mounting piece to the back side of |
the hood. Set aside wood mounting piece and screws |
for later installation. Do not discard. |
• Remove junction box cover and knockout. |
• Install strain relief onto back or top of hood. |
Additional Materials:
•120V 60Hz. 15 or 20 Amp, 2 wire with ground. Properly grounded branch circuit.
•Strain relief for junction box.
•7″ round metal duct or
• Remove all tape and packing material from the |
hood, duct transition and motor. |
11