Installation Instructions
11INSTALL FILTERS
•Remove protective film covering the filters.
•Insert the filter into the “C” clips mounted to the top of the vertical front panel.
•Tap the filter against one side to align with outside opening.
•Pull the filter down into the lower slots at the bottom of the filter support.
Junction
Box
"C" Clip
Filter
Support
Filters
•To remove the filters, grasp the handle, push the filter up and pull forward.
11A INSTALL OPTIONAL COMMERCIAL FILTERS
•Remove supplied filters (if installed).
•Place the filter drip trays into the horizontal channel in the filter panel, located behind the filters. The grease will drain from the filters into these trays.
•Insert the filter into the “C” clips mounted to the top of the vertical front panel.
•Position the filter in the lower slots at the bottom of the filter support.
12 INSTALL CONTROL KNOBS
•Push control knobs onto the shafts.
13FINALIZE INSTALLATION
•Refer to the operating instructions to test all controls.
18