GE JVM140K operating instructions Light Bulb Replacement, Cooktop Light/Night Light

LIGHT BULB REPLACEMENT

Cooktop Light/Night Light

To replace combination cooktop light/ night light, first disconnect

power at main fuse or circuit

REMOVE SCREW

breaker panel or pull plug.

Remove screw on right side of light compartment cover and lower cover until it stops.

Be sure bulbs

to be replaced are cool before

removing. Break the adhesive seal

by gently unscrewing the

bulbs. Replace with 40-watt incandescent bulbs (WB02X4253) available from your GE supplier.

t High in tensjLy__4.._wattbulbs (40S 1 1N/1),_w_hichare e "_va-gil-fibleinsuperm_ketgafidhar-crw-ai'E _toresl

[._nay also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Oven Light

To replace your oven light, first disconnect power at main fuse

or circuit breaker panel or pull plug. Remove the top grill by

taking out the 2 screws that hold

it in place.

Next, remove the single screw located above door near center of

oven that secures light housing. Replace burned-out bulb with a 30-watt incandescent bulb

(WB02X4235), available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a solution

of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and

enamel surfaces with this solution; ammonia will darken metal.

29