GE JVM152J manual Questiom? @ Use This Problem Solver, circuit breaker, Door not securely closed

Questiom?

@Use This Problem Solver

~

PROBLEM	POSSIBLE CAUSE AND REMEDY
OVEN WILL NOT	● A fuse in your home maybe blown or the circuit breaker tripped. Replace fuse or reset
COME ON	circuit breaker.
	● Unplug your microwave oven, then plug it back in.
	● Make sure 3-prong plug on oven is filly inserted into wall receptacle.
CONTROL PANEL	● Door not securely closed.
LIGHTED, YET OVEN	Q START must be touched after entering cooking selection.
WILL NOT START	● Another selection entered rdready in oven and CLEAR/OFF not touched to cancel it.
	. Make sure you have entered cooking time after touching TIME COOK I & II.
	. CLEAR/OFF was touched accidentily. Reset cooking program and touch START.
	● Make sure you have entered a temperature after touching TEMP COOK/HOLD.
	s Make sure you entered a code num~r a&r touching Aum COOK, AU~ ROAST,
	AUTO DEFROST or AU~ REHEAT.
FOODS ARE EITHER	. Cooking times may vary because of starting food temperature, food density or amount
OVERCOOKED OR	of foods in oven. Touch TIME COOK I & II and additional cooking time for completion,
UNDERCOOKED	● Incorrect power level entered. ch~kcookbook for recommended power level.
	● Dish was not romted, turned or stirred, Some dishes require specific instructions.
	Check cookbook or recipe for instructions.
	Q Too many dishes in oven at same time. Cooking time must be increased when cooking
	more than one food item. Check cookbook time recommendations.
	● Dish not completely covered as directed during Auto Cook.
	● Previous microwaving lefi humidity or moisture in oven, thus lessening the cooking
	time in Auto Cook function.
	● Certain vegetables need a standing time after using Auto Cook, Check Automatic
	Cooking Control Guide.
	● probe not insefied properly into meat or dish when using Temp Cook/Hold or Auto
	Roast functions. Check cookbook for specific instructions.
“PRObE” APPEARS	● Probe has been forgotten or not seated properly in oven wall when using Temp
ON DISPLAY	Cook/Hold or Auto Roast.
“Error” APPEARS	Q During Auto Cook or Auto Reheat program, the door was opened before steam could
ON DISPLAY	be detected.

All these things are normal with your microwave oven:

●Steam or vapor escaping from around the do-or.

●Light reflection around door or outer case.

●Dimming oven light and change in blower sound may occur while operating at power levels other than high.

●Dull thumping sound while oven is operating.

●Some TV-Radio interference might be noticed while using your microwave oven. It’s similar to the interference caused by other small appliances and does not indicate a problem with your oven.

If you need more help... call, toll free: GE Answer Center” / 800.626.2000 / consumer information service

30