GE JVM172J warranty ~m ..-.----j~uJ, The Exhamt Feature, =,$h, ‘% +, Grounding Instructions

~m;..-.----j~uJ

When NIGHT LIGHT pad is	Never operate your hood without
touched, the hood light operates	the filter in place. In situations
at a lower intensity for use as	where flaming might occur on
a night light.	surfaces below hood, filter will
	retard entry of flames into the unit.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with a 30-watt GE bulb (WB02X4235) available from your GE supplier.

I

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. You may add about 1 tablespoon of ammonia to the water, providing it does not touch the filters or enamel surfaces because ammonia tends to darken metal. Wash the smoke and spatter shield with a solution of warm water and detergent.

The Exhamt

Feature

SMOKE & SPA~ER SHIELD

The exhaust hood feature on your microwave oven is equipped with two metal filters which collect grease. When the fan is operated, air is drawn up through the filters and is then discharged through the provided venting to the outside. The hood also has a light for illuminating the counter space.

To remove grease filter, grasp the “finger ring” on the filter and slide to the rear. Then pull filter downward and to the front. The filter will drop out.

\

To replace grease filter, slide the filter in the frame slot on the back of the opening.

Pull filter upward and to the front to lock into place.

To clean grease filter, soak, then agitate filter in a solution of hot water and detergent. Don’t use ammonia or other alkali because it will darken metal. Light brushing can be used to remove embedded dirt. Rinse, shake and remove moisture before replacing. Filters should be cleaned at least once a month.

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This-appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1)

WARNING–Improper

use of the grounding plug can result in a risk of electric ;hock.

=,$h

‘%

+

	INSURE PROPER
	GROUND EXISTS
Fig. 1	BEFORE USE

Consult a qualified electrician or service technician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Where a standard two-prong wall receptacle is encountered, it is your personal responsibility and obligation to have it replaced with

aproperly grounded three-prong wall receptacle.

Do not under any circumstance cut or remove the third @round) prong from the power cord.

Do not use an adapter plug with this appliance.

Do not use an extension cord with this appliance.

29